channel 02
The Walkie-Talkie
A walkie-talkie that speaks Morse. Open this page on two devices, pick the same channel, and talk — messages travel as sound and decode live on the other side. Audio never leaves your devices.
You're invited — private channel
This walkie-talkie is already tuned to your partner's frequency. Join to start listening — your browser will ask for the microphone (that's how the walkie-talkie hears them).
sound
audible · 660/440 Hz — anyone nearby hears the beeps
environment
sets squelch + volume for the room
tuning
?
The tone's pitch. Both walkies must match — easiest via the band buttons above.?
Noise gate: signals must beat the amber tick on the meter to count. Raise it in noisy rooms, lower it for faint senders.best results: devices within 2 m · same channel · 10–25 WPM · no Bluetooth speakers · whisper channel is silent to most ears nearby
How to talk between two devices
- 01 — Open morsecodeverse.com/walkie-talkie/ on both devices.
- 02 — Easiest: hit invite partner (top-right of the console) and open the link on the second device — it arrives pre-tuned. Or pick the same sound mode + environment manually. Want a channel of your own? Hit 1:1 private channel — one side rolls it and shares the link; the other side just opens it and lands pre-tuned.
- 03 — Press LISTEN and allow the microphone on both.
- 04 — Tap CQ · ping: a listening partner’s walkie-talkie answers QSL automatically and both screens show ✓ linked — that’s your “we’re connected” moment.
- 05 — Type, hit PTT, and watch it appear on the other screen. Reply with R · roger.
- 06 — Every walkie-talkie gets a callsign (like K2X — tap it to change). Once partners know each other, messages travel addressed the ham way — N7Q DE K2X, “to N7Q from K2X” — and traffic for other callsigns stays out of your log unless you turn on monitor mode.
It’s half-duplex like a real walkie-talkie: it mutes its own ears while transmitting, then goes back to listening. The receiver locks onto the sender's speed automatically. Every message ends with ·−·−· (the ham-radio AR "end of message" prosign, +) followed by a two-character checksum — that's how the other side can stamp a message ✓ verified. Just need to convert text without the two-way parts? Use the plain translator.